Rotate the whole cube so that the two faces whose colours match the cubie are F and R: the big T is now on either F or R. Rotate the top layer until the side (not top) face of this cubie extends one of the short T's the cubie's top face now matches the colour of one of the adjacent side faces. Step 3: Middle layer edges Īt the start of this step, you should have an upside-down 'T' shape of four correctly placed cubies on each of the side faces and the down face should be solved.įind an edge cubie on the top layer that has two colours on it that are not that of the up face: this cubie will now be moved to the middle layer. Once the up face is completely solved, flip the cube over completely, so that the up face is on the bottom and the down (D) face is on the top, and proceed to the next step. From there, repeat the sequence as above. If the cubie is correct but it is incorrectly oriented, perform the same sequence once to move it to the bottom layer. Keep going until the correct cubie is placed. If the sequence puts another corner cubie in the relevant upper corner that is not the correct colours, do not stop the sequence. Perform the following sequence either once, three times or five times until the corner is in the right place and orientation: it is directly below the place where it should be. If, for example, its colours are white (as the up colour), red and green, turn the bottom layer until it is a corner on both the red and green faces, i.e. Step 2: Up face corners įind one of the corner cubies on the bottom layer that has one face as the up colour. Once the up face has a cross on it (regardless of whether any corners are correctly coloured as well) with the edge cubies on the correct side faces, this step is complete. This will restore your up face cross, and the side colours will now match the side faces. Once they are all in the bottom layer, move them back to the top by turning each side twice. If all of them already match, or if you can fix them just by turning U, great! Otherwise, pick one of them, turn U until it matches, and then move that cubie to the bottom by turning the side it is on twice.

For each edge cubie in the cross, we want the colour of its other side (the one that is not on U) to match the side face it is on. You now have a cross of the up colour on U. This will flip the cubie so that the U colour is facing upwards. If one of them is incorrectly oriented, place it on the edge connecting the front (F) and up (U) faces, and perform the following sequence once: We want the U colour on each of them to be facing upwards, so that they form a cross on U. Now find the four edge cubies that have a side with that colour, and twist the cube to place them on the top layer. Rotate the cube so that this is the up (U) face. If when you begin a step the end condition is already fulfilled, simply move on to the following step. Only rotate the cube (thus changing the sides referred to by the letters) when instructed to. While performing one of the move sequences during a step, don't rotate the cube. Finally, if it is followed by a 2, turn it twice i.e. If it is followed by an apostrophe, it means counterclockwise (e.g. R), it is rotated clockwise (as seen face-on). If a side's letter is shown unaltered (e.g. While many notations exist, this seems to be pretty much the most common and standardized. Now that that's out of the way, let's begin! When you position a corner piece or edge piece correctly, its colours are in their respective faces.A center piece is always a center piece AND is always in the same place relative to the other center pieces.A corner piece is always a corner piece.There are some things that are very important to know: 9 Step 7: Top layer corners (orientation).8 Step 6: Top layer corners (placement).

Rubik cube flip two corners